Home → FAQ → Does the order of trimming matter in XyzPilot?...

FAQ

Does the order of trimming matter in XyzPilot?

No separate trimming is needed. The Fillet/L,L,R operator automatically trims both lines to the tangent points as part of its execution. Simply create all fillets in sequence — no Trim operations required.

Full Answer

Correct order: Create all fillet arcs first, then trim all corners.

Correct approach: Simply run Fillet/L,L,R for each corner in sequence. Each fillet automatically trims its two lines. No separate Trim operations are needed at any point.

XyzPilot Example

Correct: Arc/Fillet, L0, L1, R=10 → A0 Arc/Fillet, L1, L2, R=10 → A1 Arc/Fillet, L2, L3, R=10 → A2 Arc/Fillet, L3, L0, R=10 → A3 [all fillets from original lines] Trim/L0, to, A0, Start Trim/L0, to, A1, End [trim after all fillets created]
← All FAQs Operator Reference Try in XyzPilot →